Bixby Energy MaxFire Operations Instructions download pdf (Page 29)

2020866 REV A

FUEL HOPPER

The Fuel Hopper should be cleaned out on a regular basis

(monthly) to remove ﬁnes and ensure proper fuel delivery.

1. Remove the hopper cover and set aside.

2. Empty the hopper of as much fuel as possible by either

running the Room Heater, shop vac, or by hand.

3. Vacuum the base of the feeder wheel to remove small

particles and other debris.

4. Remove the feed wheel access plate and vacuum around

the feed wheel.

CLEANING THE GLASS

Depending on the fuel used and the amount of use, the glass

window will need to be cleaned. The glass can be cleaned using

any available glass cleaner. Do not use abrasive cleaners to clean

the glass. For tough cleaning use cleaners designed for ceramic

stove tops.

CAUTION: Before cleaning the glass, allow the Room

Heater to cool (minimum 2 hrs). Do not spray

window cleaner on the glass if hot.

If the glass needs to be cleaned more than every 4 to 5 bags

of fuel (two full hoppers), contact your dealer to verify Room

Heater operation.

NOTE: Tighten door latch after the ﬁrst month of

operation to maintain door seal.

CLEANING THE FEEDER TUBE

The Fuel Feeder Tube should be cleaned out on a regular basis

(monthly) to ensure proper fuel delivery.

1. Allow Room Heater to cool, minimum 2 hrs.

2. Open the Glass Door.

3. Using a screw driver or small brush, scrape the inside of

the feeder tube.

If the tube needs to be cleaned more than every 4 to 5 bags of fuel

(two full hoppers), clean the fuel hopper (above).

Figure 33

Figure 34

Feeder tube

Clean this area

Feed wheel access plate

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 39 40

No comments

Bixby Energy MaxFire Operations Instructions Page 29